2006 31PC elbows - regular or 2" rise????


M

More Leverage

New member
I am replacing the manifolds and elbows on my 31PC (merc 496) and need to know if I have standard elbows or 2" rise. Short of calling TAG, does anyone know?
 
More Leverage said:
I am replacing the manifolds and elbows on my 31PC (merc 496) and need to know if I have standard elbows or 2" rise. Short of calling TAG, does anyone know?
Click to expand...

Give me your engine serial number and I can look it up
 
More Leverage said:
Give me your engine serial number and I can look it up



OW618146
Ow618187
Model 4-S4202JU S

Thank you!!!
Click to expand...

Had more trouble then I thought I would but Fun Times on iboats came up with this link which should help you figure it out
https://www.hardin-marine.com/t-496_measure.aspx

More info
Chris from CMI here, we build the risers, if you want to call me tomorrow at 920-886-8237, I can get you the dimensions to tell which one you have.

Chris

Also
bbcmi said at off shore only
The standard riser is 5 1/4" from the bottom of the flange to the center of the outlet and the 2" taller is 7 1/4" from the bottom of the flange to the center of the outlet. The outlet is the flared out portion.
 
thank you. I broke down today and cut the shrink wrap enough to open the hatch. It looks like 2" rise but I will measure tomorrow. This link helps a lot. By the way, not fun working in 33 degrees with ripping wind. Where is spring???!!!!!
 
More Leverage said:
thank you. I broke down today and cut the shrink wrap enough to open the hatch. It looks like 2" rise but I will measure tomorrow. This link helps a lot. By the way, not fun working in 33 degrees with ripping wind. Where is spring???!!!!!
Click to expand...

Don't know but sure wish it would show up soon. Been to the Artic and Antarctic and it is F--ing cold for this old guy and he has had enough
 
You must log in or register to reply here.
Back
Top