Search results

Temp gauge not reading, did some trouble shooting: 1. Pulled the plug of the sending unit and grounded it out, that's supposed to peg the gauge, it did nothing. Gauge stayed at at zero 2. Replaced the sending unit. Nothing. 3. Grounded out the plug wire with the new sending unit in, gauge read...

Have twin 4.3's in my '95 27PC and last winter I knocked, what appears to be, a ground wire loose. One end appears to be connected to the starboard engine ground lug and I'm not sure where to terminate the other end? Are the motors grounded to each other and this became disconnected from the...

Are the OEM trim tab cylinders still available? Or do I just measure and buy from Bennett?

I've asked TAG and they sent me where they think the strainer should be but it's not there. I know the marina put a new A/C unit in when I bought the boat but I assume the strainer location didn't change. I've looked in the bilge, bilge wall, around the A/C unit...no luck. Any help would be...

Is there an aftermarket, drop-in steering wheel that doesn't require the column to be changed out to fit the existing hub/spline?

Anyone have a template for a '95 27PC?

Anyone ever replace the bracket on the pump? Mines completely rusted but still functions fine, found a bracket online so I assume it's just a matter of moving the components to the new bracket? '95 27PC

The only access I see to the unit is through the floor vent below the locker, am I missing another point of entry? Also need to find the sea strainer, I've never cleaned it. I did a few searches on the forum but couldn't find anything.

New in original packaging, never used, order by mistake. Make an offer. https://www.ebay.com/itm/184230018717

Was shaving an issue with my water pressure being low. Went down to check the line coming out of the tank to the pump and it was completely cracked. When I grabbed it it pulled right off. What are my options? Thinking I have to stick a smaller diameter pipe down the existing feed tube and...

Anyone know where to find the gaskets that hold the screen in the oval ports on the PC's?

'95 27PC - Plug into shore power, charger "DC Available" light comes on but the amp meter gauge doesn't move off zero? I checked it yesterday after being out all day, plugged it in and the meter still didn't move. I don't have the manual for the OEM charger [requested from TAG] but is there a...

Does anyone know of an existing template for adding custom matting i.e. Hydro Turf to a swim platform for a '95 27PC? I have access to an automated cutting machine and if there was template it would be a breeze to import it into the machine and cut.

Are these Carling Contour II's?

on my 27PC I have a short that I isolated somewhere between the ignition switch and the ignition coil. With the 12v wire connected, I have a dead ignition siwtch. I know a bad tach can short out the wire, I un-hooked the tach and got the same issue at the ignition switch. Is there any easy way...

Dropped my '95 27PC las week, when I tried to start one of the ignitions [can't remember which] it turned over twice and then nothing...dead. Started the other engine and let it run for a few minutes, finally the other engine turned over and started. Got the boat to the slip fine and parked the...

Tried searching for a previous thread on this but one of my front speakers is out in the lounge and i can't figure out hoe to access them. I tried reaching around under the cover that's in front the them but can't figure it out. As another side note, i replaced the arch speakers and for some...

Looking to replace the cabin bulbs in my '95 27PC to LED, anyone know what bulbs they use? I haven't taken the covers off the lights since I was nervous of breaking themto see the bulbs but now a few have burned out so I have to take the plunge. Any advise for getting them off? Do they make...

I was having this problem late last year and it seems to still be an issue. I bypassed my hot water tank [not working and don't really need it at this time] by connecting the cold and hot line together. now I'm having low water pressure issue on all the taps but especially in the galley and head...

Thinking of getting away from the twist on's. Mine are all starting to leak and is a pain in the ass to keep changing...