Search results

Great! Appreciate that.

You mean check for continuity or an actual voltage reading?

Temp gauge not reading, did some trouble shooting: 1. Pulled the plug of the sending unit and grounded it out, that's supposed to peg the gauge, it did nothing. Gauge stayed at at zero 2. Replaced the sending unit. Nothing. 3. Grounded out the plug wire with the new sending unit in, gauge read...

I have a '95 27PC with 4.3's and it's very tight down there. Room in front, but the side are really tough to work on. The top of mine has some room but there's a million sharp screws hinging down from the hatch hinge that love to bloody you hands when reaching over the top.

Thanks. I'll start by looking at the port engine ground lug and see if there's an empty ring terminal and go from there.

No, it barely makes it past the port motor and all those items are on the port wall. It's 10ga wire I believe.

Posted

Have twin 4.3's in my '95 27PC and last winter I knocked, what appears to be, a ground wire loose. One end appears to be connected to the starboard engine ground lug and I'm not sure where to terminate the other end? Are the motors grounded to each other and this became disconnected from the...

I picked up the O ring set and I'm going to try and replace those first.

Will do. Thanks

I found one very close to what i have now 13.5", 13.75" is available. How easy to replace? From what i see online there's a copper nipple coming off the upper hinger through the transom

So just measure it and order from Bennett?

Are the OEM trim tab cylinders still available? Or do I just measure and buy from Bennett?

I've asked TAG and they sent me where they think the strainer should be but it's not there. I know the marina put a new A/C unit in when I bought the boat but I assume the strainer location didn't change. I've looked in the bilge, bilge wall, around the A/C unit...no luck. Any help would be...

Is there an aftermarket, drop-in steering wheel that doesn't require the column to be changed out to fit the existing hub/spline?

Anyone have a template for a '95 27PC?

Anyone ever replace the bracket on the pump? Mines completely rusted but still functions fine, found a bracket online so I assume it's just a matter of moving the components to the new bracket? '95 27PC

The only access I see to the unit is through the floor vent below the locker, am I missing another point of entry? Also need to find the sea strainer, I've never cleaned it. I did a few searches on the forum but couldn't find anything.

New in original packaging, never used, order by mistake. Make an offer. https://www.ebay.com/itm/184230018717