Search results

Has anyone installed a fuel valve to switch between tanks for the fuel lines for generator on a 41 PC ?

Has anyone removed the shower drain screen? Does it pull up or does it unscrew?

Been trying to sign in and have not been able to. A different format kept coming up. Finally saw the normal format and it didn?t recognize my username

I have installed on a new to me 41 pc new electronics. For sale is 958 Chartplotter and open array complete system including boxes and cables. Prefer to sell as complete setup. Asking $750.00

Started a few winter projects on my 2002 41 pc. Removed all original electronics which meant new dash panels. Panels are being made by ?Boatoutfitters? in Fl. Should be done in couple of weeks. Will post pics later. Changed rocker switches to push button switches. Removed cockpit fridge and...

I am looking to retire soon and want to lower all my payments. Prefer to trade my 09 40 PC for a 41 PC. Or sell. My 40 has 408 hrs on IPS 500. Asking $274,532.00.

Replaced E120 Classic with E120W so I needed to replace the dash panels. Went from Burl wood to the black with gray grain panels. Reconfigured all the gauges on the dash and centered MFD on helm wheel.

Has anyone made this upgrade ? What cable adapters are available to switch from Raymarine E120 classic to E120W

After a lousy spring to get boat ready I finally splashed yesterday on a less then perfect day. White caps, rough water and high winds, whose complaining a day on the water is better then a day at work. Boat ran great and I am ready for the boating season here in New Jersey

Any one have any problems with fuel gauges not working? 2009 40 PC with Volvo IPS 500. No reading on the EVC display nor the 4 in 1 gauge. Check the sending units and they show good. Ground wires were checked also. It seems to appear as a problem with the two units as something they share. Any...

Was winteizing boat yesterday , starboard engine was fine. Flushed engine with fresh water and brought temp up, cleaned strainer , hooked up antifreeze bucket . All good. Went to port engine , hooked up water to flush turned on ignition and nothing except gear engaged on display . Checked shift...

Has anyone upgraded their Isotherm Fridge/ Freezer to the drawer type? If so did you find a direct fit that is also dual voltage 12 v/ 120 ac?

After all the rain we’ve had here in New Jersey I was finally able to finish polishing , bottom paint, coat pods and install new underwater lights. Dropping her in 8 am tomorrow before the afternoon rain again

I own an 09 40 PC , one fuel gauge does not work while starting engines. This was a problem when I purchased the boat last July. I cleaned all wire connections and made sure were all tight. I did a little testing today and came up with the following results. Test A, 1. Turned on port ignition...

Does anyone know the part number for the o-ring for the drain plug? I am getting ready to change gear oil prior to launch next week and want to have the new ones on hand. Can’t find the number in any schematic.

Has anyone used Amsoil for the IPS pods ? A friend of mine researched and said Volvo s gear oil for pods is made by Mobil. Makes sense since Volvo is not in the oil business. The marine Amsoil synthetic has been tested and is suitable for high pressure anti foaming and has been tested with 10%...

Has anyone had to have the finish redone on the steps from the cockpit to the salon? they have a wood grain coating with three rubber strips. My middle step that opens to storage rubs the wall and has slightly damaged the material on the wall. I need to trim the side of the step and have it redone

What is the best antifouling system being used by owners. I boat in Northeast. Was thinking of priming with Interlux primcon then either a hard epoxy bottom paint or Tri lux 33 in white which I have had excellent results on outdrives and inboard running gear in the past.

I own an 09 Formula 40 Pc with IPS 500. When I purchased this boat in July I only had starboard fuel gauge. I checked ground, power and all other wires for loose or corroded connections. All are good. My issue is when you turn on port ignition fuel gauge doesn't work. When I turn on starboard...

After selling my '07 45 a month or so ago I am finally close to finalizing my purchase of an '09 40PC. Will be closing on the 30th of June and running it from Massachusetts to New Jersey Saturday the first. I'll miss the 45 but in my plan to retire and down size I'm back in a 40 which is still a...