axapowell
Member
One of my winter projects was to replace my cockpit seat skins. It wasn’t because they were real bad, with no rips or tears, just one small seam staring to separate (this can be repaired prior to putting these on).
Mainly wanted to replace the factory foam.
Formula uses a large cell foam for excellent water release, but it isn’t as comfortable as a more closed cell foam. Our boat stays dry in a boathouse and the canvas is always up in bad weather, so this isn’t a concern of ours.
I have all all of the foam and skins for the cockpit except the helm seats. There are 8 pieces total and the pictures are right before the skins were carefully removed.
2003 37PC. Again, these are used, but in very good condition. I replaced them with factory skins ($$$) and had my upholstery “Guy” recover them. If yours are marginal and you are looking for a less expensive route than factory or aftermarket, these are for you! Make me an offer.
Dave
Mainly wanted to replace the factory foam.
Formula uses a large cell foam for excellent water release, but it isn’t as comfortable as a more closed cell foam. Our boat stays dry in a boathouse and the canvas is always up in bad weather, so this isn’t a concern of ours.
I have all all of the foam and skins for the cockpit except the helm seats. There are 8 pieces total and the pictures are right before the skins were carefully removed.
2003 37PC. Again, these are used, but in very good condition. I replaced them with factory skins ($$$) and had my upholstery “Guy” recover them. If yours are marginal and you are looking for a less expensive route than factory or aftermarket, these are for you! Make me an offer.
Dave
