Search results

try Touchtronics as it would be their receiver

I had my installer do the install and trim work. He did a fantastic job and he charged proportionally for it too! :oops:

It was about 5 years ago and a 31PC since sold, but if I recall the bolts they could not get back out of the nut inserts were cut and replaced with new toggle bolts. Good choice with NautikFlor. I went with their Cherry & Holly and was very pleased. Good luck with your project.

When I first bought my 37PC my key fob did not work either until I read that it needs to be enrolled in the receiver. Hopefully the attached helps you too. My receiver is behind the dash similar to the attached photo. Once successful it will just work and you will hear the corresponding relays...

I have no idea what that Royce device is or does or where you found it... I have never seen it before nor can find any info on it. I attached some wiring numbers and wire colors from my build if they help you troubleshoot/check for 12VDC at the galley. There is a pigtail #14180 on my build if...

you have a main breaker for shore power 1 and 2 under the very aft starboard cushion/seat that may be tripped or inadvertently pushed off if you stow equipment in there?

Does your 37 PC have a 12V cig recept as shown below? It surely isn't sticking out for me or its time for new glasses. Got one in cockpit but hard to believe not in cabin.

and I didn't mess around trying to climb down under to reach the nuts either. This was a lot faster to swap the ladder out

Reviving this thread in the hopes my issue isn't as bad as what you guys went through. A neighbor was nice enough to take a couple of photos for me when I pulled up over the dock. Would you remember what size this SS roller bolt is so I can have a couple with me next time I can get a chance to...

I am selling my 2006 31 PC with twin Mercruiser 6.2 with 566 hrs. I have owned her for 4 years and moving up to another Formula. I have been meticulous with both interior and exterior including mechanical systems. Have all service records by Mercury dealer. Recent upgrades include...

Now I don't feel so bad when I see what others paid for their hull repairs. It certainly is more than you think. Sorry I didn't take better before photos and can't locate my final after repair photos. I was able to get three quotes in my area and I chose the lowest as they had the best...

yeah the amazon photo is wrong but the part number of 206-083S in the link is correct for the 30A model. It actually has a long time trip of 40 1/2 amps in 72 sec. I attached a photo of my old one. Had a very angry sea a couple of weeks ago and seawater splashed in the starboard stern...

I have twin Mercruiser 6.2 MPI Horizons. Launched my boat today and fired up the engines for the first time this season and noticed a strange clicking sound coming from the helm dash. Sounds like a relay perfectly timed every few seconds click-on and click-off. Each engine does this and with...

I am installing a smartcraft network now. That end goes to the engine(s) CAN bus harness Hope this helps.

I need to access my power panel and notice it requires a special key or wrench to open. Does Formula have this key stowed someplace that I have missed? Thanks

Has anyone purchased and installed the Mercury Vesselview Mobile kit? I have been searching the web trying to determine how to install on twin engines. There are plenty of videos and docs that instruct for single engine installations but nothing (that I can find anyway) for twin engines. I can't...

Are you saying Formula doesn't have these dash panels available anymore? I was hoping to replace the old C80 chartplotter and remove the ST60 and use whoever MFD I decide and not concern myself trying to make it finish with existing cutout.

After more than a few connection issues that I have had the past couple of years with my Raymarine C80 and DSM 300 sounder I decided that maybe its time to upgrade. I have read that this is a common problem boaters are having with the DSM 300 with intermittent connections and loss of depth data...

I had problems and frustrations with my DSM 300 sounder and C80 GPS chartplotter last couple of seasons quitting on me of course when I really needed to know my depth. I have read some messages on the forums that this is a common issue with the DSM 300. I was considering to replace the DSM 300...

So after the haul out last fall I noticed I had lost my starboard trim tab. Well sure explains the poor handling I experienced towards the end of season. I purchased two new Bennett trim tabs and lower hinge pins and plan to replace just prior to new bottom paint this spring. The mounting holes...