Recent content by lakecabin36

We have a 1990 PC36 with a Norcold DE-704D refrigerator/freezer (original) that is getting quite noisy. I am concerned it might be on its last legs. Anyone ever replace this model? If so, with what? Jim

The black rectangular plate where the valve manifold is attached is right in front of the tank area where the pick up tubes are located. The plate is screwed to a fiberglassed plywood panel and if I took the manifold plate off, cut about the top 3-4 inches of the panel, I would have access to...

I may have to replace the antisiphon valve on my starboard fuel tank on my 1990 Formula 36 PC. As far as I can tell, there is no way to get to that area of the tank to replace it. There is no access where the valve is located. Anyone have any ideas?

I have a 1990 Formula 36PC (not express) with twin Mercruiser 7.4 liter Bluewater Inboards. Our first summer was last year and we battled water and debris in the starboard fuel tank most of the summer and went through about 5 fuel/water separator filters. We had very little problem towards the...

I have a 1990 Formula 36PC with twin inboard 454's, gas with carb's. I was idling out on Lake Michigan and the starboard engine quit. It would turn over but not fire. Thinking it was a fuel filter (I've had some water/sediment issues with that side, but has been much better), I anchored and...

We just purchased our 1990 Formula 36 PC. It has sat in storage for the most of the last 3 years, and after putting her in the water, filling the tanks full, we plugged the starboard fuel filter after 30 minutes running. I have replaced it twice since then (usually after being out in rougher...

I have 2 of these plug-ins towards the stern of our 1990 36PC, one on each side. I attached a picture (I think). I believe they are 12 volt. I am not sure what they are for? Can anyone help?

So excited to get our 1990 Formula 36PC in the water next week. We bought it late last year and have been working on cleaning it, etc. ever since. This is our first large boat and our first slip in South Haven, MI. It's great to be part of the forum.